1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year > 1964 1/2 - 1965

Oct 64 San Jose Fastback trunk lid fitment

<< < (2/2)

J_Speegle:

--- Quote from: DKutz on October 16, 2017, 07:25:51 PM ---Ok finally took pictures yesterday.  Trunk will not move to make rear flush.  Is the lid just warped?  Or tweaked?

--- End quote ---

Looks like it might have been twisted

From the pictures it looks fairly level and close at the drivers side front corner but down/low in the passenger side front corner while it does not match the profile well at either of the rear corners to the end caps though you have it close (well at least from the pictures on the passenger side) to the top rear corner of the quarter panels.

DKutz:

--- Quote from: J_Speegle on October 16, 2017, 07:37:05 PM ---Looks like it might have been twisted

From the pictures it looks fairly level and close at the drivers side front corner but down/low in the passenger side front corner while it does not match the profile well at either of the rear corners to the end caps though you have it close (well at least from the pictures on the passenger side) to the top rear corner of the quarter panels.

--- End quote ---

I know there is some adjustment for the front corners, I am more worried about the back corners to the caps alignment

CharlesTurner:
The RH back corner needs to come up.

Is there a weather-strip glued on?  Do you have the thin one or thick?

DKutz:
again I am more worried or curious about the read edge where it meets the caps.  Is this supposed to be flush acroos the trunk to the caps?

CharlesTurner:
It should fit reasonably well and lines match up. 

Navigation

[0] Message Index

[*] Previous page