« previous next »
Pages: [1] 2 3   Go Down

Author Topic: D code - Starter Cable bracket picture  (Read 12378 times)

Offline john_simms

  • Newbie
  • *
  • Posts: 49
D code - Starter Cable bracket picture
« on: February 25, 2012, 02:14:07 PM »
Does anyone have a picture that shows the correct positioning of the two clamps that mount to the motor mount bolts and hold the starter cable in position?  1964 1/2, D-code V-8.

Thanks.

John
« Last Edit: May 17, 2020, 11:40:34 PM by J_Speegle »
Logged

Offline jwc66k

  • Hero Member
  • *****
  • Posts: 7140
Re: Starter Cable bracket picture
« Reply #1 on: February 25, 2012, 03:35:35 PM »
The bracket (maybe two) are between the bolt and the mount, angled out and down a bit for the cable to clear the bracket and manifold. If you have a heat shield, it goes between the mount and the engine.
Jim
Logged
I promise to be politically correct in all my posts to keep the BBBB from vociferating.

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24234
Re: Starter Cable bracket picture
« Reply #2 on: February 25, 2012, 07:35:12 PM »
First question is always (if you don't provide it ) is;

John when and where was your car built? (or a guess from the door tag info ;)
Logged
Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24234
Re: Starter Cable bracket picture
« Reply #3 on: February 25, 2012, 07:37:24 PM »
Quote from: J_Speegle on February 25, 2012, 07:35:12 PM
First question is always (if you don't provide it ) is;

John when and where was your car built? (or a guess from the door tag info ;)

Difficult to find a good picture with that big generator in the way but we'll try
Logged
Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7624
Re: Starter Cable bracket picture
« Reply #4 on: February 25, 2012, 08:05:44 PM »
Quote from: J_Speegle on February 25, 2012, 07:37:24 PM
Difficult to find a good picture with that big generator in the way but we'll try

Excuses, excuses!   8) ;D

Logged
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin

Offline jwc66k

  • Hero Member
  • *****
  • Posts: 7140
Re: Starter Cable bracket picture
« Reply #5 on: February 25, 2012, 08:22:43 PM »
An electronic surplus store item?  ;)
Jim
Logged
I promise to be politically correct in all my posts to keep the BBBB from vociferating.

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7624
Re: Starter Cable bracket picture
« Reply #6 on: February 25, 2012, 08:51:20 PM »
Quote from: jwc66k on February 25, 2012, 08:22:43 PM
An electronic surplus store item?  ;)
Jim

Open to speculation I suppose.  The clamp is unique as it has a lock tab to hold the ends together.
Logged
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin

Offline kutzoh

  • Gold Level Subscriber
  • Full Member
  • *****
  • Posts: 220
Re: Starter Cable bracket picture
« Reply #7 on: February 25, 2012, 08:52:16 PM »
John-
   Is it these clamps:

http://www.virginiaclassicmustang.com/65-73-STARTER-CABLE-BRACKETS-PAIR-FITS-260-289-302-351W-390-428CJ-P1154C1063.aspx

If so, I'd like to see a picture also. I have a set but haven't installed them as I'm not sure if they're correct to use on my coupe.

Greg
Logged
64.5 Dearborn coupe, D-Code, June 28, 1964   Skylight Blue

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7624
Re: Starter Cable bracket picture
« Reply #8 on: February 25, 2012, 08:53:25 PM »
Quote from: kutzoh on February 25, 2012, 08:52:16 PM
John-
   Is it these clamps:

http://www.virginiaclassicmustang.com/65-73-STARTER-CABLE-BRACKETS-PAIR-FITS-260-289-302-351W-390-428CJ-P1154C1063.aspx

If so, I'd like to see a picture also. I have a set but haven't installed them as I'm not sure if they're correct to use on my coupe.

Greg

Guess I mis-read the original post...  :(
Logged
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24234
Re: Starter Cable bracket picture
« Reply #9 on: February 25, 2012, 08:55:56 PM »
Quote from: caspian65 on February 25, 2012, 08:05:44 PM
Excuses, excuses!   8) ;D

Beat me too it - but I did write we'll try ......... and you can through making good on my statement ;) 

Its all about teamwork !!
Logged
Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline kutzoh

  • Gold Level Subscriber
  • Full Member
  • *****
  • Posts: 220
Re: Starter Cable bracket picture
« Reply #10 on: February 25, 2012, 08:59:03 PM »
Since John and I both have D-codes, were these originally used from the factory?

Greg
Logged
64.5 Dearborn coupe, D-Code, June 28, 1964   Skylight Blue

Offline john_simms

  • Newbie
  • *
  • Posts: 49
Re: Starter Cable bracket picture
« Reply #11 on: February 25, 2012, 09:55:32 PM »
Quote from: kutzoh on February 25, 2012, 08:52:16 PM
John-
   Is it these clamps:

http://www.virginiaclassicmustang.com/65-73-STARTER-CABLE-BRACKETS-PAIR-FITS-260-289-302-351W-390-428CJ-P1154C1063.aspx

If so, I'd like to see a picture also. I have a set but haven't installed them as I'm not sure if they're correct to use on my coupe.

Greg

Yes those are the clamps I was referring to.  My car has two, but they've always just hung off of the starter cable and were never bolted to anything.  There is also a woven fiber sleeve over the starter wire that fits in there someplace too.  It is much like the sleeve that is over the oil pressure sensor wire, only much larger in diameter.
Logged

Offline john_simms

  • Newbie
  • *
  • Posts: 49
Re: Starter Cable bracket picture
« Reply #12 on: February 25, 2012, 09:57:33 PM »
Quote from: caspian65 on February 25, 2012, 08:05:44 PM
Excuses, excuses!   8) ;D



I actually need one of those too.  Someone was making those in their garage and getting $35 dollars a pop for them.  I can't remember if I saw them here or over on the Vintage Ford Mustang website.
« Last Edit: February 25, 2012, 10:09:57 PM by john_simms »
Logged

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7624
Re: Starter Cable bracket picture
« Reply #13 on: February 25, 2012, 10:01:24 PM »
Quote from: john_simms on February 25, 2012, 09:57:33 PM
I actually need one of those too.  Someone was making those in there garage and getting $35 dollars a pop for them.  I can't remember if I saw them here or over on the Vintage Ford Mustang website.

Think they were on ebay a while back.
Logged
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin

Offline carlite65

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 2372
Re: Starter Cable bracket picture
« Reply #14 on: February 25, 2012, 10:17:31 PM »
Quote from: john_simms on February 25, 2012, 09:57:33 PM
I actually need one of those too.  Someone was making those in their garage and getting $35 dollars a pop for them.  I can't remember if I saw them here or over on the Vintage Ford Mustang website.

i think these folks were making them 
 http://buckeyeclassiccarrestoration.com/Buckeye_Classic_Car_Restoration/Home.html
Logged
5F09C331248
Pages: [1] 2 3   Go Up
« previous next »