Author Topic: Radio Restoration  (Read 1996 times)

Offline Sunlitgold68

  • Sr. Member
  • ****
  • Posts: 437
Radio Restoration
« on: January 25, 2010, 09:39:34 AM »
Pulled my old Philco AM out of the box where it's been for the last 20 years and looked it over. The radio is completely original and was working last time it was in the car. At what point do you consider sending your radio off to be restored? It is such a small section showing after you attach the bezel.
8T01C204XXX

Built May 14th, 1968

Original Owners, custom ordered from Clemmons Ford, Henderson NC

Offline gjz30075

  • Full Member
  • ***
  • Posts: 209
Re: Radio Restoration
« Reply #1 on: January 25, 2010, 12:59:26 PM »
Do you have a picture of the 'blemish'?
Greg Z

Offline Sunlitgold68

  • Sr. Member
  • ****
  • Posts: 437
Re: Radio Restoration
« Reply #2 on: January 25, 2010, 01:14:12 PM »
It's just the silver line is faded that runs horizontally. The lens is not cracked. Some of the white numbers are not perfectly white anymore.
8T01C204XXX

Built May 14th, 1968

Original Owners, custom ordered from Clemmons Ford, Henderson NC

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7624
Re: Radio Restoration
« Reply #3 on: January 25, 2010, 03:53:05 PM »
I've never been able to find a good way to restore the chrome line other than using something like chrome/silver paint.

Frank might be able to find an automotive paint that could replicate it.
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin

Offline thefordshow

  • Full Member
  • ***
  • Posts: 105
  • fordcountry@bell.net
Re: Radio Restoration
« Reply #4 on: January 25, 2010, 05:27:01 PM »
Plastic model "silver foil" used for doing chrome side trim on kits. You can buy it at some of the better hobby shops. 

Offline RogerArrick

  • Jr. Member
  • **
  • Posts: 58
Re: Radio Restoration
« Reply #5 on: July 18, 2011, 09:18:20 PM »
I've redone worn silver lines across 2 radios and both owners were happy with the results.
I used: Duplicolor CHROME spray can #CS101

I removed the entire bezel but you probably don't have to do that.  Just mask real good and run some fine scotchbrite over it and make sure it's real clean. 

Spray the can in the air the first time to begin a good stream of paint.
Do 2 pass, then stop.
___________________________________________________________
Roger Arrick
Tyler, TX
Home of an awesome group of Mustang rebuilders