Hey All,
Replacing my new to me ?69 GT350 rim blow switch. It was rock hard when taking the old one out and I spent the better part of yesterday chipping all the petrified rubber ( or glue) out.
My problem is when I went to put the new repro switch in, it did not want to go in without a fight. Of course I ruined the switch in the process. I did notice that the gap in the wheel is about 2mm smaller than the width of the switch. Is this normal? If it matters, the wheel is dated July 68. The gap on the wheel is approximately 7.5-8mm and the switch is about 10mm.
Thanks,
Tom