ConcoursMustang Forums

Restoring - General discussions that span across many different groups of years and models => Drivetrain => Topic started by: Sunlitgold68 on December 17, 2009, 05:06:18 PM

Title: Engine Gauge Feed Wire
Post by: Sunlitgold68 on December 17, 2009, 05:06:18 PM

Are the reproduction engine gauge feed wirings concours correct or should an OEM be located?

Title: Re: Engine Gauge Feed Wire
Post by: Murf on December 17, 2009, 05:11:05 PM

I picked up a set from NPD made by Alloy Metal Products and was so happy with them.  They looked and functioned as they should, and also purchased a set of Engineering number tags from ECS to add to the new harnesses and really think the entire thing looks as good as the day it left the San Jose assembly plant.  I would give both the wiring and the tags my blessing!

Title: Re: Engine Gauge Feed Wire
Post by: Sunlitgold68 on December 17, 2009, 05:17:42 PM

Does this one look correct? I have seen some that looked different, I know the hookup part is red.

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=350104343266&viewitem=&sspagename=STRK%3AMEWAX%3AIT

Title: Re: Engine Gauge Feed Wire
Post by: Bob Gaines on December 18, 2009, 01:21:20 AM

I think they are very nice but the plug ends are slightly different when compared to originals. It is mostly because of the mold lines. It is hard to find a Ginny where the white wire hasn't degraded or the white hasn't started to flake off the wire. Bob