ConcoursMustang Forums
1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1966 Mustang => Topic started by: bryancobb on April 26, 2012, 09:18:57 PM
-
What are the "corners" of a well-liner suppose to look like? I'm talking about the areas on both sides where the hydraulic cylinders are. It looks like I need to do some kind of mitered corners and use contact cement.
Also, how far inward from the ends of the round steel rod should the tension springs be placed?
-
No Help?
-
PM sent
-
Bryan-
Here are some photos of an original dated "8-64." Looks like they sewed it and strategically cut it to get the radius correct. Hope this helps. Gary
-
From that top picture I think I can see the detail I needed. Thanks