« previous next »
Pages: [1]   Go Down

Author Topic: Cowl to Inner Fender Brace Tubes  (Read 1294 times)

Offline bryancobb

  • Silver Level Subscriber
  • Hero Member
  • ****
  • Posts: 1077
  • 2009 Ridn' Around
Cowl to Inner Fender Brace Tubes
« on: May 09, 2010, 01:10:37 PM »
On my 66 convt...  What hardware is supposed to be used at the front end of the two diagonal tube braces that go from the cowl to the R and L inner fenders.  One was off the car and the other had an original bolt with star washer frm the inside of the engine compartment, but inside the wheelwell it had A SQUARE THREADED PLATE about1.75" square.  I don't think this is correct.  Well I guess I found the answer...My Osborne book shows the square plate to be correct.  Does anyone have one, I'm missing one?

P/N C5ZB-16D112
« Last Edit: May 09, 2010, 01:15:29 PM by bryancobb »
Logged
66 Metuch Conv
Nightmist, Std Blu Int
6T08C223904    76A       K         22       15c     21      6        6
                      BODY  COLOR   TRIM    DATE   DSO   AXLE  XMSN
   C/O  785                                   (rotation #)
   16    C14   6T08C223904        (weld bay 16, bucked MAR 14)

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7624
Re: Cowl to Inner Fender Brace Tubes
« Reply #1 on: May 09, 2010, 10:50:39 PM »
If you can't find someone that has one, would be relatively easy to fabricate since you have one to use as a pattern.
Logged
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin
Pages: [1]   Go Up
« previous next »