1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year > 1967 Mustang

Hood Letter 1967 + Alignment

<< < (3/4) > >>

Fastback2013:
Hello,

I must admit...reading all those detailled comments, tips and tricks, I am feeling like a boy scout :P
But... very educating, because for me this is all a trip back in 'memory lane' !! Knowing that I wasn't born at the time this car was made :o
I will do my very, very best for measuring it thoroughly.
Thanks for the help !!
Kind regards,
Jeroen

C6ZZGT:

--- Quote from: dave6768 on September 20, 2017, 10:26:04 PM ---In 67, the turn signal hood was also part of the Sports Sprint package.

I used a piece of Kraft paper and just marked the center position and then aligned it with the front edge of the hood.  There was a rumple in the middle, but was able to pull it flat in the location of the letters.

Dave

--- End quote ---

+1 what Dave said ! Exactly how the wifes car is

Ralf:
Jeroen,
Any news on your template?
Great to hearing from you.

Thx
Ralf

Ralf:
Do not know what about Geroen. No info here, no reply via pn I wrote some days ago.

Anyone else who can support to send me e.g. a dimensional scetch/drawing (like position of the letters and position of the holes)?

However, I still hope Jeroen could provide a feedback on his template soon.

Fastback2013:
Hello Ralf,

I send you a mail from my phone, but apparently it didn't arrived. :(
I had the flu last week, so I couldn't do what I had promised, sorry for that.
Tomorrow morning I'll set up everything and I'll report back.
Kind regards,
Jeroen 

Navigation

[0] Message Index

[#] Next page

[*] Previous page