Restoring - General discussions that span across many different groups of years and models > Drivetrain
FE oil gallery check valve
67gta289:
I see that the FE has an oil gallery check valve, identified in the 1960-68 MPC as part number C4TZ-6026-A, but identified in the 1965-72 MPC as 383024.
Are these available, because I can't seem to find anything?
The picture includes MPC listings, illustration, and pictures of the part.
TIA John
jwc66k:
C4TZ-6026-A is called a plug here - https://www.jensales.com/content/ppp/ford-engine-parts-manual-fo-p-eng-330.pdf
Jim
67gta289:
Jim - thanks for checking. Since that is a manual of unknown (to me) origin, I'll be a better referee than in the NFL and give the nod to Ford documents. I went back and checked seven single-year Ford car parts & accessories catalogs, as well as three different master parts & accessories catalogs, and updated the attached file.
The original design used part B8A-6026-A, per P&A catalogs through 1964.
In 1965 the part designated was C4TZ-6026-A.
In the 1975 dated MPCs, the 383024 number was used.
It dawned on me that the Obsolete, Supersede, Interchange catalog might help, and it sure did. The C4TZ-6026-A was replaced by (RB) 383024-S. There is no mention of B8A-6026-A.
Since all of these clearly state an "air bleed" function, these are not a simple plug. Confirmed by the one I carefully extracted a few days ago.
mtinkham:
Thank you for sharing John. What was your method of extraction, if you don't mind sharing?
67gta289:
Since it is inserted from the front of the block, after I removed the corresponding cup plug at the rear, I inserted a 1/4" diameter rod of sufficient length and proceeded to tap lightly with small hammer.
Navigation
[0] Message Index
[#] Next page
Go to full version