ConcoursMustang Forums
1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1971 - 1973 => Topic started by: mac1971 on October 06, 2015, 10:55:14 PM
-
So, when I got the car, there was intermittent grinding of the starter gear and the flex plate. Its too bad, because someone went to the trouble of putting a nice new starter in the car, but due to the grinding, ruined the starter mesh gear and this was more then likely caused by the following flex plate which I removed today from the engine. My question is can the ring gear be replaced on the original flex plate or do I have to just get a new one? Where can I get it repaired or where can I purchase the correct replacement for my 429cj? I will get the new piece for the starter in time also. Thanks in advance for any help.
-
Yes they can be (ring gear) replaced. Been a while since I last had one done. Its the center section that is slightly different from other applications if I remember correctly
Most likely any used one you find will be well worn also.
-
Not selling Summit, but found several on their site.
http://www.summitracing.com/search/part-type/flywheel-and-flexplate-ring-gears?SortBy=Default&SortOrder=Ascending&tw=ring%20gear&sw=Flywheel%20and%20Flexplate%20Ring%20Gears
A good engine shop with a leveling plate should be able to remove, re-weld and balance for you. Talk to whomever is going to do your engine work.