ConcoursMustang Forums
Restoring - General discussions that span across many different groups of years and models => Misc Items => Topic started by: BMRBill on October 29, 2009, 06:51:05 PM
-
I'm in process of installing the original tac in the 66 shelby I am restoring. It was not hooked up when I disassembled the car so I am trying to find out the proper routing of the wire that is run to the neg side of the coil. Hope somebody has some info on this.
-
The wire red wire to the coil was on the 65 Shelby tach . The 66 Shelby tach is routed to the factory location in the wiring harness. The repro 66 Shelby tach uses the coil location also.
-
This might help someone
(http://i44.photobucket.com/albums/f49/firetrainer/66%20Shelby%20Detals/66ShelbyTach2.jpg)
-
Jeff could you fax me that wiring drawing I can't really make all of it out ?
Fax 1217 498 7154
Thanks
Bill
-
Jeff could you fax me that wiring drawing I can't really make all of it out ?
No fax on this end. Maybe email me (PM for the address) and I can send it as an attachment. Have you tried to save the picture I posted to your hard drive then open it with a viewer to increase the size?
Just a thought