1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year > 1970 Boss
70 B2 spindle detail
J_Speegle:
Most hardware and places like Orchard Supply carry a green fabric tape that can be spit down the length ( to produce a section that matches the original width and is long enough to go around the spindle upper shaft) to make a substitute for the original. Just make sure you cut the new edge rather than just rippling it
Crgjohnson:
Thanks Jeff.
Most helpful as you always are!
Motang:
Craig-were you able to source this?
Crgjohnson:
I think I have enough for one more B2. Let me check. Can'T remember where I sourced it>
Craig
specialed:
green thread tape
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version