1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year > 1967 Mustang

67-68 styled steel wheel trim rings

<< < (2/2)

67gta289:
Here is a picture comparing the 67 version on the left at 2.25" wide (deep), and the 68 (and NOS) version at 2" wide.

mtinkham:

--- Quote from: 67gta289 on January 06, 2019, 06:36:15 PM ---Back again... I had time to measure the widths and my original 1967 versions are 1/4" wider than the NOS parts I had picked up.  I would call the 67 at 2-1/4" while the 68 is 2". 

I suspect that from a service perspective Ford felt that the 2" wide version was sufficient?
--- End quote ---


I am looking for trim rings for my signature car. Based on this thread, 1967 styled steel trim rings should be 2-1/4" deep. While WCCC list trim rings for 1967 Cougars as 1-3/4" deep. Is this discrepancy attributed to a Mustang vs. Cougar detail? I would like to make sure I am looking for the correct depth trim rings.

Thanks, Mark.

Navigation

[0] Message Index

[*] Previous page