1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year > 1969 Mustang
1969 rocker molding install
Chris Thauberger:
I realize this post is older than I am, but though I would post for the next guy.
You may or may not find this helpful. :)
Chris
Chris Thauberger:
--- Quote from: jmlay on April 02, 2012, 10:36:48 PM ---My San Jose car had studs welded to the body, same as the pillar medians.:
Installed with:
--- End quote ---
This stud welder is used to install copper studs that go into a slide hammer for pulling dents.
NOT the "T" top studs seen around the window openings and later rockers.
Chris
Brian Conway:
Thanks for the post. Always great to have the original FORD instructions. Brian
Navigation
[0] Message Index
[*] Previous page
Go to full version