« previous next »
Pages: 1 [2]   Go Down

Author Topic: Replacement of entire floor pan  (Read 7760 times)

Offline Ryan Miller

  • Newbie
  • *
  • Posts: 8
Re: Replacement of entire floor pan
« Reply #15 on: February 13, 2014, 02:22:51 PM »
Date codes and panel numbers are easily reproduced... ;) :)
Logged

Online jwc66k

  • Hero Member
  • *****
  • Posts: 7135
Re: Replacement of entire floor pan
« Reply #16 on: February 13, 2014, 04:36:54 PM »
I was at a local VW shop yesterday where there was a 64 Karman Ghia having it's rusted out floor pans replaced. Same technique for removal of the old pans (drill out old welds), same problems in replacement metal (single good source and expensive), same procedure for welding in the new pan (wire weld small holes and grind), same situation for putting the seat base back in (the same welding technique) everything was the same, and it looked good.
Jim
Logged
I promise to be politically correct in all my posts to keep the BBBB from vociferating.

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24232
Re: Replacement of entire floor pan
« Reply #17 on: February 14, 2014, 12:58:04 AM »
Quote from: Ryan Miller on February 13, 2014, 02:22:51 PM
Date codes and panel numbers are easily reproduced... ;) :)

Like to see that  :o
Logged
Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7624
Re: Replacement of entire floor pan
« Reply #18 on: February 14, 2014, 02:53:19 PM »
Quote from: J_Speegle on February 14, 2014, 12:58:04 AM
Like to see that  :o

Cut dates out of old sheet metal and weld in.  The body guy I use has a little collection of date codes, lol.
Logged
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24232
Re: Replacement of entire floor pan
« Reply #19 on: February 14, 2014, 08:26:02 PM »
Quote from: caspian65 on February 14, 2014, 02:53:19 PM
Cut dates out of old sheet metal and weld in.  The body guy I use has a little collection of date codes, lol.

Seen that a few times ;)   From the comment thought the suggestion Ryan Miller was making that he was reproducing the stampings rather than transferring
Logged
Jeff Speegle

Anything worth doing is worth doing concours ;)
Pages: 1 [2]   Go Up
« previous next »