« previous next »
Pages: [1]   Go Down

Author Topic: Clock pointer SOS  (Read 577 times)

Offline AJ

  • Full Member
  • ***
  • Posts: 126
Clock pointer SOS
« on: December 13, 2023, 03:21:38 PM »
Needing advice.   Anyone know the orientation of the 3 metal shims and 1 oring  shown in the photo.   Pieces flew in all directions when i finally persuaded the knob off the clock pointer.  i didn?t see which went where.  Thanks
Logged
Adrian Jacobs
70 Boss 302  Dearborn, 11/22/69, original calypso paint,  original family ownership.
70 GT500 , 02/26/69, a/c auto, candy red

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24232
Re: Clock pointer SOS
« Reply #1 on: December 13, 2023, 04:58:24 PM »
For some reason I think I recall all went on the adjusting stem. Been ALONG time since I had one apart and hopefully someone else can confirm yes or no.
Logged
Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline Eragon

  • Newbie
  • *
  • Posts: 5
Re: Clock pointer SOS
« Reply #2 on: December 20, 2023, 07:33:40 AM »
Hello AJ. I have reworked my clock some weeks ago. I haven't had such metal shims in mine. The clock hands were placed directly on the shaft... Unfortunately i did not make any photos. Greetings Frank
Logged

Offline rnegless

  • Jr. Member
  • **
  • Posts: 58
Re: Clock pointer SOS
« Reply #3 on: December 20, 2023, 04:42:35 PM »
Here's a picture of one on my pile.
Logged
68 San Jose 390 GT 4sp 3:25 Decor 12/29/67

Offline 67gta289

  • Hero Member
  • *****
  • Posts: 3025
Re: Clock pointer SOS
« Reply #4 on: December 20, 2023, 07:26:46 PM »
This should help:
Logged
John
67 289 GTA Dec 20 1966 San Jose
7R02C156xxx
MCA 74660
Pages: [1]   Go Up
« previous next »