ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1969 Mustang => Topic started by: SCJSTU on December 17, 2021, 01:15:21 PM

Title: correct nose cone for 351W starter 4 speed
Post by: SCJSTU on December 17, 2021, 01:15:21 PM

did a search and nothing popped up

anyone got a part number?

car built Jan 1969

Thanks,

Title: Re: correct nose cone for 351W starter 4 speed
Post by: Bob Gaines on December 17, 2021, 08:38:16 PM

Quote from: SCJSTU on December 17, 2021, 01:15:21 PM

did a search and nothing popped up

anyone got a part number?

car built Jan 1969

Thanks,

That is a very hard to find nose cone compared to the common automatic version. I don't have a part number to order from because that is basically useless in this case. I have gotten used to identifying them from the unique physical appearance since the the numbers are typically covered with dirt and grease.  The engineering number that is cast into the part that I have seen frequently is C5TF-11131-A. There is also a DOOF-11131-B that looks the same. Obviously the DOOF -B would be after the fact however the outward appearance once mount is identical in all aspects. There are probably others but like I said I am mainly concerned with what the nose looks like once mounted . I consequently haven't paid a lot attention to the various numbers. I have only have been concerned with what it looks like from a judging standpoint when I look under the car. Also keep in mind that starting in 1968 production that a wrong nose cone can cause flywheel/flexplate engagement problems.

Title: Re: correct nose cone for 351W starter 4 speed
Post by: SCJSTU on December 21, 2021, 02:06:56 PM

looks like I needed the long nose cone........short one was on it and would just free spin most the time......long cone kicks it off every time.....thanks

Title: Re: correct nose cone for 351W starter 4 speed
Post by: agwinged on February 01, 2024, 06:54:59 PM

Is there a list of nose cones stamped numbers and application someplace.  I've looked through my Ford MPC and couldn't find one. 

Title: Re: correct nose cone for 351W starter 4 speed
Post by: Bob Gaines on February 01, 2024, 07:50:01 PM

Pretty simple as far as application on the Mustang. The two ear noses cones regardless of if auto or manual were all the same 65-67 . Starting in 68 there was a change in teeth on the flywheel to 164 which triggered a change in the manual trans starter nose cone to be the wider variety compared to the  narrow one used on all automatic versions 65-70 . If you want the original look stay away from any marked that start with D1,D2 etc. Those starter nose cones were improved with strength gussets in the casting that are different looking on the inside and outside of the part.

Title: Re: correct nose cone for 351W starter 4 speed
Post by: Wills70 on February 06, 2024, 07:28:21 PM

Some information I have saved
(http://)