« previous next »
Pages: [1]   Go Down

Author Topic: Push rod length  (Read 192 times)

Offline JeffWS

  • Newbie
  • *
  • Posts: 20
Push rod length
« on: April 12, 2024, 11:06:37 PM »
Interested in determining which engine uses push rods that are approximately 6 3/16" (6.1875) in length.

Any idea?

Thank you
Logged
Jeff

Offline RoyceP

  • Hero Member
  • *****
  • Posts: 1509
Re: Push rod length
« Reply #1 on: April 13, 2024, 11:31:18 AM »
Lots of them - it might help if we knew what diameter, the end design, and perhaps the application. Far too many options otherwise.


Here's a guide:
https://www.pushrods.net/custom-pushrod-selection
« Last Edit: April 13, 2024, 11:33:39 AM by RoyceP »
Logged
1968 W code 427 Cougar XR-7 GTE Feb 23 Dearborn C6 / 3.50 open
1968 R code 428CJ Cougar XR-7 May 13 Dearborn C6 / 3.91 T - Lock

Offline JeffWS

  • Newbie
  • *
  • Posts: 20
Re: Push rod length
« Reply #2 on: April 17, 2024, 09:50:00 AM »
5/16"

Ball on both ends.

Looks like 289 302 type but different length.

Looks like 581S or 5116 series on the Smith Bros. Site.
Logged
Jeff
Pages: [1]   Go Up
« previous next »