1
1964 1/2 - 1965 / Re: Holes in dash
« Last post by J_Speegle on April 29, 2024, 11:34:09 PM »Here are some pictures of the bottom of the dash - Hope thy help
#1
#2
#3
#4
#5
#6
#7
#8
#1
#2
#3
#4
#5
#6
#7
#8
How about these from AMK?
How about these from AMK?it looks like you found some if you choose to be like the assemblyline.
That's interesting. They seem to be hard to come by. When I search for 376770-s100 screw that is listed in the fastener spreadsheet and on the assembly manual page N8-8505 I come up empty.Simply put, 376770-S100 is the assembly line screw for 1967 and 68 Mustang (probably others too). It is also the the service replacement screw for 1967 thru 1970 Mustangs as called out in the 1975 edition of "Ford Car Parts" (aka the infamous MPC). Apparently it is not reproduced or available.
I use these:Check the size required.
AMK Products P/N B-11557
How about these from AMK?The picture didn't copy, but the screw is 382968-S45, 10-24X1.0 SST, chrome plated, Pozi-Drive. It should be the correct thread size, but is 1 inch long, whereas 376770-S100 is 7/8 inch long. It is the assembly line specified screw for 69 and up.
I'm trying to do the final welding on the dash. Curious if anyone has pictures of an original dash, especially underneath. The first picture is the possible location of GT fog lights switch. Does that location and size of the hole look correct? I would also like to weld all other holes under the dash. Some are pretty obvious that they were added at a later point. Others I can't tell for sure. Thanks. BTW the car is upside down on a rotisserie.The 1965 and 66 Fog Lamp switch is not under the dash but located on the "slope" about halfway up between the lower bend and the edge of the instrument panel. I'll try to get a picture and dimensions later.