1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year > 1969 Boss

1969 B2 Starter Part #

<< < (3/3)

Bob Gaines:
I was side stepping the question because I am away from my parts to measure. Maybe someone else can measure.

hopey:

--- Quote from: Bossbill on August 30, 2023, 01:31:14 PM ---I seem to recall that the block plate opening and nose diameter where it fits into the plate were a different size than earlier starter noses.
Do we have the diameter of the nose where it fit into the blockplate opening?

--- End quote ---

Not sure about the diameter, I have never really noticed a difference. I would measure but I am in the middle of final preparations & cleaning my BOSS for next weeks MCA Grand National. What I do know is that getting the correct depth so you engage the ring gear fully, there is a long nose (2-3/8 inch effective depth if my memory is correct) and a shorter 2inch .  As Bob states they are often mixed up and if you see a 4speed MT long nose 164tooth starter at a swap meet, grab it!

Gcodecowboy:
What should the part number be on the nose cone of a C7AF-11001-F starter?

Navigation

[0] Message Index

[*] Previous page