« previous next »
Pages: 1 [2]   Go Down

Author Topic: Aircraft Stripper on Stainless Moldings?  (Read 5467 times)

Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 9001
Re: Aircraft Stripper on Stainless Moldings?
« Reply #15 on: August 17, 2020, 11:33:49 PM »
Quote from: tobkob on August 17, 2020, 10:00:12 PM
If you use a wheel be very careful...one slip and you've had a bad day... :'(

TOB
Very true if done on the car . Also true if doing off the car. I use a buffing wheel and have learned the hard way to stay focused.One wrong move and the wheel can grab the trim and ether twist it or send it flying.
Logged
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24232
Re: Aircraft Stripper on Stainless Moldings?
« Reply #16 on: August 18, 2020, 12:20:37 AM »
Same thing with removing them. Ends can be dangerous. Sliced open a cheek once when I wasn't watching close enough. At least I missed my eye  ::)
Logged
Jeff Speegle

Anything worth doing is worth doing concours ;)
Pages: 1 [2]   Go Up
« previous next »