ConcoursMustang Forums
Marketplace => Wanted Ads => Topic started by: C5ZZKGT on June 13, 2011, 09:00:27 PM
-
C5TA-18827-A is what I understand the part number is, either a GOOD used, NOS or CORRECT Reproduction-(if they exist) THANKS!!!!
-
Rick, I've heard you can get these sometime from deadnutson. You may try calling them.
Dave
http://www.deadnutson.com/page/page/2958685.htm
-
Dave, Thanks!! I sent Jack an Email, Rick
-
Bump......still looking......
-
I actually found one in my parts stash-kinda ugly-how can I refinish it? I've cleaned it up with some steel wool but it needs more before I put it on my car.
-
I actually found one in my parts stash-kinda ugly-how can I refinish it? I've cleaned it up with some steel wool but it needs more before I put it on my car.
If you had one of Eastwoods inexpensive zinc plating kits you could hook it and dip it in and about 3 minutes later it is plated. You can adjust the sheen with a light rub from a towel to a more abrasive extra fine steel wool. Usually I buff it with a course towel and it is good to go. You can of course send in to your local plater with a minimum order and hope they don't break the wire off. I hope this helps . Bob
-
Thanks Bob!! This does help, I'll check out the Eastwood kit.
-
Still looking for a NICE one.
I've got the old one I had refinished the best I could and installed it-looks ok, but the connector has been replaced with a generic one and the wire is actually too short to plug in right.........Please check around for me, I'd sure appreciate it. Thanks!!
-
If you are still looking for one, I just listed one in My Ebay Store. It is a Good Original. Andrew
http://stores.ebay.com/MagMustangs
-
I'll look around and if I find one you can have it for the price of shipping....