Non-Mustang Ford & Mercury Models > Cougar 1967-73

1968 Cougar S code/4 speed driveshaft markings

(1/2) > >>

PacificaXR7GT:
I decided to clean up and restore my driveshaft while replacing the u-joints. Looking for some help/confirmation on the markings. My Cougar GT was built in San Jose in January 68 and has an S code 390, wide ratio 4 speed, and open 3.25 9" rear end.

So far, I have found light yellow paint on all non-machined surfaces of the slip yoke.

I found reddish orange on both ends of the driveshaft.

There is a 1/4" stripe about 10 inches from the differential end (measuring from the weld seam) of the driveshaft. It appears to be a bright orange, lighter than the orange on the ends.

There is a "X" along the seam about 13 inches from the differential end. It appears to be yellow.

There are three wider stripes beginning about 18 inches from the differential end. Each stripe is about 1/2" to 5/8" wide and they are spaced about 2" from each other. From the differential end they appear to be PINK - LIGHT BLUE - WHITE.

After the three stripes, there are two 1 inch lines aligned roughly on the opposite side of the shaft from the weld seam. The first is about 1/4 inch from the white stripe and they are about 2 inches apart. They appear to be white.

I am fairly certain about the pink and light blue stripes because I was able to find a few flecks of vibrant color under the surface rust and grime. I am not certain about the white stripe and I would appreciate any guidance from folks who are in the know. I have searched high and low and have not found any information on this driveshaft, only on the C6 version.

Thanks in advance.

J_Speegle:
Sorry there are not allot of 4 speed Cougars out there to find the build sheets in or original cars with legible markings left. Adding to the mix is that you have a San Jose built cars and they were pretty good about tossing buildsheets in the trash rather than the car - but not always.

Looked through my pictures and don't have another example to compare.

The yellow on the trans yoke is interesting. Not something I would have expected

Sorry can't be of any assistance currently

PacificaXR7GT:
Thanks very much for checking! I appreciate the response.

sportyworty:
Build Sheet for a 68 R code Cougar optioned with a 4 speed is called out
BL RED LGR unfortunately different than your S code PacificaXR7. Figured I?d check for you but may as well share. It?s Extremely rare verified info regardless for someone someday :)

RoyceP:
Info from the 1969 MPC - the 1968 R code and S code should be identical.

Navigation

[0] Message Index

[#] Next page