Topic: 1965 Convertible quarter trim panels

[Anghelrestorations]

I just finished recovering these original trim panels, filling in the holes where the speakers were, and fixing cracks etc.  I have seen cars where they have trim panel screws in the front area by the door jambs to hold these panels in place, but dont see that the assembly manual calls for this.  Wondering if others have seen this or the screws attaching to the body are just like the assembly manual shows here which shows 4 screws per panel to the body.  This is a Dearborn build April of 1965. 

20230703_175625 by Marcus Anghel, on Flickr

20230703_175954 by Marcus Anghel, on Flickr

20230703_180740 by Marcus Anghel, on Flickr

[CharlesTurner]

There's 2 screws on the back, should see the holes in the panels and holes in the car.  2 more screws are used, one below the window crank and one at the end of the grained metal part


Looks like the small snaps were used, the only small snap should be the one on top of the grained metal piece.  The other 3 have flared out bottoms.

[J_Speegle]

..........................I have seen cars where they have trim panel screws in the front area by the door jambs to hold these panels in place, but dont see that the assembly manual calls for this.  Wondering if others have seen this or the screws attaching to the body are just like the assembly manual shows here which shows 4 screws per panel to the body.  This is a Dearborn build April of 1965. 

Unrestored examples from Dearborn cars built around the same time period as you listed above

[Anghelrestorations]

Ok thanks.....no fasteners on the lower front portion then.  Just like assembly manual shows...that was an easy one.