ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1968 Mustang => Topic started by: sigtauenus on July 17, 2010, 07:17:15 PM

Title: 68 deluxe dash emblem placement
Post by: sigtauenus on July 17, 2010, 07:17:15 PM

I bought the Scott Drake dash pieces with the woodgrain on a metal insert. As such there are no predrilled holes for the deluxe dash emblem on the upper right trim panel.

Can I please get a measurement for the emblem?

Thanks,
Sam

Title: Re: 68 deluxe dash emblem placement
Post by: Bill Cabaniss on July 21, 2010, 06:52:23 PM

 If you are talking about the piece above the glove box mine has these measurements. This measurement is from the outside edge of the emblem to the inside edge of the trim panel. From the trim panel straight up to the emblem is 5/8 inch. From the edge of the emblem straight right to the inside edge of the trim panel is 3 1/4 inches. If you need more just ask. Bill.

Title: Re: 68 deluxe dash emblem placement
Post by: sigtauenus on July 22, 2010, 04:31:55 PM

Thanks Much!!