Topic: 4-spd Toploader Hurst shifter linkage bushings

[K-HESS]

Here is one thats from a small block. Only the mounting bracket and reverse rod are different on the bog block. Mounting brackets are available in reproduction not sure about the reverse rod. This one is about as cheap as you will find posted on the internet for sale.

[Bob Gaines]

Here is one thats from a small block. Only the mounting bracket and reverse rod are different on the bog block. Mounting brackets are available in reproduction not sure about the reverse rod. This one is about as cheap as you will find posted on the internet for sale.

FYI  Jay Cushman is a well known parts vendor specializing in ford performance parts that has been around for decades.

[Angela]

Thank you! I will give Jay a call today.

[Angela]

Thanks again for everyone's help. I picked up the parts (above) from Jay.

I now need to locate D0ZA-7B112-D and a 0ZR-03C bracket.

Admittedly being unfamiliar with these parts, can anyone recommend their favorite resource for disassembly and rebuilding of these shifter mechanisms? I see that Holley has a rebuild document for the aftermarket Hurst shifter assy., but thus far I haven't seen a similar document published for the Ford OEM parts.

Thanks!

[70-Conv_4sp]

Go to this website, they are an authorized rebuild-er for OEM hurst shifters

https://www.shifterdoc.com/HurstRebuildForm.pdf

70-Conv_4sp (Cougar, XR7}

[70-Conv_4sp]

Also - This is a company that reproduces many factory transmission shifter mechanism, both Automatic and manual etc...,
just in case no one has mentioned them before.

https://www.kickdownrods.com/

70-Conv_4sp