ConcoursMustang Forums
1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1967 Shelby => Topic started by: 1967 eight barrel on November 05, 2015, 03:48:27 PM
-
What are the factory finishes? Zinc, black paint, phos?
-
Rear shackles are bare/natural steel with the area around where the shafts were attached blued from the heat
Rear leaf spring plates are bare/natural steel- like never plate steel. Can be a bite brighter where the metal is stretched to form the plates
Examples are shown in the Natural Finish article in each (year's) Library section of this web site
-
Thank you for replying. I haven't spent enough time here trying to figure out all the resources available. Thank you for responding.
-
Rear shackles are bare/natural steel with the area around where the shafts were attached blued from the heat
Rear leaf spring plates are bare/natural steel- like never plate steel. Can be a bite brighter where the metal is stretched to form the plates
Examples are shown in the Natural Finish article in each (year's) Library section of this web site
Something to add while on the subject of shackles is that the driver side is a duel exhaust special one which is 2 halves and consists of one half being the plate with one post and the other half the same . They puzzle together. This was a factory attempt to put the upper bolt in a more accessible position. Repros are available (NPD)or you can fabricate a more authentic looking one (if the other side is genuine and not repro) using parts of two shackles to make one driver side special shackle.
-
Something to add while on the subject of shackles is that the driver side is a duel exhaust special one which is 2 halves and consists of one half being the plate with one post and the other half the same . They puzzle together. This was a factory attempt to put the upper bolt in a more accessible position. Repros are available (NPD)or you can fabricate a more authentic looking one (if the other side is genuine and not repro) using parts of two shackles to make one driver side special shackle.
I believe the repro's are described as 'PAINTED"
(slightly off topic) Now on the dual exhaust shackles, is it true there was ONLY ONE shackle that was the special "L" design while the passengers side used the same as a single exhaust cars?...is this true for all early Mustangs or just Shelby specifically? (since the O.P. has a 67 Shelby, I thought I would ask)
-
I believe the repro's are described as 'PAINTED"
(slightly off topic) Now on the dual exhaust shackles, is it true there was ONLY ONE shackle that was the special "L" design while the passengers side used the same as a single exhaust cars?...is this true for all early Mustangs or just Shelby specifically? (since the O.P. has a 67 Shelby, I thought I would ask)
Yes, just the driver side was specific to factory duel exhaust according to assembly manual. I have only seen them on Shelby's to confirm but of course that is where I am mainly looking. It seemed to be phased out in 68
-
Now on the dual exhaust shackles, is it true there was ONLY ONE shackle that was the special "L" design while the passengers side used the same as a single exhaust cars?...is this true for all early Mustangs or just Shelby specifically?
Both Mustangs with factory dual exhaust and Shelby's from the cars I've seen and owned
-
This makes sense as well, as far as the leaf spring shackles go. There is much less room on the one side of the fuel tank, which makes sense why they split the shackles as they did.