Restoring - General discussions that span across many different groups of years and models > Drivetrain

Transmission tags...

<< < (2/2)

J_Speegle:
Was thinking last night I wonder if this is a task for an engraver since that would not bend, twist or depress the metal

Bob Gaines:

--- Quote from: J_Speegle on November 16, 2017, 11:28:44 PM ---Was thinking last night I wonder if this is a task for an engraver since that would not bend, twist or depress the metal

--- End quote ---
+1. The steel tag is very hard and would be difficult to get at the correct consistent depth while not depressing the metal.

mungus:
Funnily enough earlier today I spoke to a fellow Mustang owner who lives quite close by, who has a trophy engraving business.
She thinks she would be able to do it with a rotary engraver. Might need a couple of passes to get the right cut.
Apparently the more common laser ones can't replicate the depth etc.
I'm dropping the old one around in the next few days for her to have a go...
Its cheap, so no loss if its a dud.

Navigation

[0] Message Index

[*] Previous page