Non-Mustang Ford & Mercury Models > Cougar 1967-73

Cougar Taillight restoration

(1/2) > >>

Bossbill:
This topic crosses between 67 Cougars and the Shelby cars that used the taillight assembly.

Here I'm talking specifically about the cast taillight part.

Any restoration tips or gotchas?

J_Speegle:
Ones I've done/used were always in good condition so don't have any specific hints.

I would think that the same "rules/guidelines" we associate with aluminum intakes and valve covers. Don't be aggressive during the cleaning process, don't add texture, especially in the the rear reflective surface. Maybe many of the suggestions as to cleaners and products that apply to intakes could be considered

Bossbill:
The semi-gloss black around the outside of the housing is correct?

The PO LOVED semi-gloss black -- everywhere -- so just checking.

rocket289k:
Hi Bill,

Based on the unrestored 67 tail light I have - you are correct.  Semi-gloss black on the exterior housing.  I've attached a picture of that tail light for your reference.


Ron

Bossbill:
Thanks Ron.

I carefully removed the cork gasket, which I assume is stock, rather than use the reproduction gasket. I do wonder if you can see it at all.

Navigation

[0] Message Index

[#] Next page