« previous next »
Pages: [1]   Go Down

Author Topic: correct upper 'A' arm SHAFTS  (Read 1780 times)

Offline Martin Munoz

  • Newbie
  • *
  • Posts: 3
correct upper 'A' arm SHAFTS
« on: July 31, 2012, 01:38:41 AM »
can someone advice on correct finish on upper A arm SHAFTS   for '68  GT 500
 
Logged

Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 9001
Re: correct upper 'A' arm SHAFTS
« Reply #1 on: July 31, 2012, 06:15:20 PM »
Quote from: Martin Munoz on July 31, 2012, 01:38:41 AM
can someone advice on correct finish on upper A arm SHAFTS   for '68  GT 500
The shafts were a darker bare metal , finish. I have seen them Zinc phosphate plated . Some people use gun blueing.  There should be a distinct contrast between the appearance of the darker shaft and that of the lighter shade of the upper control arm frame metal that they are installed in if you want a factory like appearance.
Logged
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby

Offline Anghelrestorations

  • Hero Member
  • *****
  • Posts: 1126
    • Anghel Restorations
Re: correct upper 'A' arm SHAFTS
« Reply #2 on: September 05, 2012, 09:37:33 PM »
Agree with Bob on this with the finish...I have some pictures of originals I can post as well.  I have also seen yellow paint dabs on the upper control arm shafts.  Just took one off a car last night and can still see what left on there although there is not much left otherwise:





Logged
Marcus Anghel
MCA National Gold Card Judge, 69-71 Mustang
SAAC National Head Judge, Boss Mustangs

www.anghelrestorations.com
www.facebook.com/anghelrestorations
www.instagram.com/anghelrestorations
Pages: [1]   Go Up
« previous next »