Recent Posts

Pages: 1 [2] 3 4 ... 10
11
Body, Paint & Sealers / Re: Interesting splash shield
« Last post by ruppstang on May 09, 2024, 09:20:13 PM »
It must be a very late service part. I never have seen pop rivets used.
12
Parts for Sale / 351W plug wires
« Last post by Big Al on May 09, 2024, 09:14:02 PM »
Marti repops  351W with orange boots, date code 2Qtr 70
slightly used  good cond -  no issues   $25
can deliver to MCA Ozark or Des Moines

Al
14
1967 Mustang / Re: 67 buck tag
« Last post by gtamustang on May 09, 2024, 05:17:50 PM »
SK is dual exhaust as only S- and K-codes received dual exhaust in 1967.
15
1966 Mustang / Re: Fastback Rear Folding Seat
« Last post by 66TotalPerf on May 09, 2024, 04:25:02 PM »
Another question. For my '66, any idea where to buy the two parts circled, 11736 and 111B82? I know 111B82 is the rubber stop mounted on the bottom side of the rear panel, however, I don't know what 11736 is.
16
1966 Mustang / Re: Fastback Rear Folding Seat
« Last post by 66TotalPerf on May 09, 2024, 04:15:00 PM »
No rush at all Jim. Thanks again!
17
1966 Mustang / Re: Fastback Rear Folding Seat
« Last post by jwc66k on May 09, 2024, 04:12:51 PM »
Now I understand. The lack of holes indicates that panel is probably a 65. I got several things this to do afternoon so it may take a couple of hours before I can measure my 66 GT Fastback.
Jim
18
Parts for Sale / 71/73 Hood
« Last post by Big Al on May 09, 2024, 04:04:56 PM »
OEM takeoff  - good condition, minor "warehouse scratches" .   center "feature line" NOT kinked.  Not NASA hood. No leading front edge trim.  No rust    $100
can deliver to MCA Ozark or Des Moines
Al
19
1966 Mustang / Re: Fastback Rear Folding Seat
« Last post by 66TotalPerf on May 09, 2024, 03:31:26 PM »
My panel, which I shared the photo of, has no mounting holes. My understanding is that for a '66+, the raised sections of both sides of this panel should have 3 in-line holes to mount to the car body.

I have all assembly manuals and confirmed the mounting steps. In the diagram attached, I don't have the holes in my panel to be able to install screws B, D, K.

I'm wondering if I can drill the missing holes and if anyone has the measurements to assist with this?

Thanks!
20
1966 Mustang / Re: Fastback Rear Folding Seat
« Last post by jwc66k on May 09, 2024, 02:58:22 PM »
That panel is the rearmost section. You can get a better idea of what is required to install stuff by getting a set of 1966 Mustang Assembly Manuals, plus a 64-65 Weld And Sealant Manual and a 64 Chassis Manual.
Jim
Pages: 1 [2] 3 4 ... 10