« Last post by wll17057 on May 05, 2024, 08:40:39 PM »
Thanks to David Knab for the picture of the trunk board.
Although it's a minor detail, I want to install a trunk board in our 1968 Metuchen Coupe. After reading some of the associated posts, the board was intended to protect the tank from the jack (?). Can anyone tell me what the board was made of, and the dimensions? I haven't found any in supplier websites and it seems easy enough to make. I have the original trunk mat, and want to add the board.
Thanks everyone.
Bill Leonard 1968 Metuchen Coupe 8T01T225520 / 65A U 2AA 31U 16 6 1
« Last post by birddog on May 05, 2024, 08:37:48 PM »
I got some dash holes welded. The first picture is directly under the ignition switch. Going off J-speegle pictures. The green circle is an under dash light. The red is not used. The other two look like clean holes. Are these factory or add on?s
The second picture is directly under the glovebox. The green circle is obviously factory. The next hole closest looks like maybe a factory hole. A little worn out. And the furthest red circle is the same size as the first but more worn and maybe rusted out. Are the red circles factory? Thanks.
« Last post by wll17057 on May 05, 2024, 08:30:12 PM »
Hi Everyone. We are pleased to let everyone know we won the AACA Sr Grand National Award for our 1968 Metuchen Coupe. This award was won April 2024 at the AACA Grand National Meet in Charlotte North Carolina, scoring a minimum of 390 out of 400 points. Thanks to everyone on the Concours Mustang Forum for all the refinement suggestions and help that we used to attain this level.
Bill Leonard 1968 Mustang Coupe Metuchen 8T01T225520 / 65A U 2AA 31U 16 6 1
« Last post by s2ms on May 05, 2024, 07:27:32 PM »
Came across an ebay auction, https://www.ebay.com/itm/135043221468, with an early style open handle lug wrench I had not seen before, #1 in the photo below with a plate on the back covering the socket opening. Anyone know that this is for?