ConcoursMustang Forums
1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1969 Mustang => Topic started by: Scott302 on March 26, 2024, 04:10:11 PM
-
I am looking for the diameter of this hole in the center of the firewall. The under dash main harness with a grommet and wires for the wiper, engine gauge feed harness and others pass through here.
Regards,
Scott
-
I would assume that is for underdash harness, 14401, and if I got to punch a feed thru hole for any harness, I measure the diameter of the grommet's groove and use a chassis punch.
Him
-
Not why I need it. I need to verify the original dimension.
Scott
-
Scott,
If nobody else answer before I get out to the shop this afternoon and slide the harness out. I'll let you know.
John
-
Scott,
If nobody else answer before I get out to the shop this afternoon and slide the harness out. I'll let you know.
John
Sorry Scott I couldn't get the harness out to measure the hole for you.
John
-
Thanks for trying.
-
It is 1 1/4 inch