ConcoursMustang Forums
Restoring - General discussions that span across many different groups of years and models => Suspension => Topic started by: BBs70fastback on January 16, 2012, 03:16:25 AM
-
1970 Sportsroof 302 2V, Dearborn, built June 17, 1970, power steering, A/C
I see that NPD sells upper and lower bushings for 1970 idler arms. Does it work well to replace these bushings and use the original idler arm vs. a complete replacement? I am trying to keep the original parts where possible.
As far as evaluating the condition of the bushings, my idler arm has no up and down play in it, but the bushings are weather cracked. Does the “return to center” bushing issue apply to power steering idler arms? If so, which bushing is supposed to be so stiff you cannot turn it by hand? I can turn my upper bushing (the end that attaches to the mounting bracket) by hand. Or is it the bushing on the other end that is supposed to be very stiff?
Also, the threads past the nut on the end of the mounting bracket that contains the upper bushing has raised marks that appear to prevent the nut from being removed. Can the bushing be replaced without removing these raised spots on the threads?
Thank you,
Barry
-
Yes even though you have power steering you need the correct idler arm bushings (actually) on P/s cars it's more important! The bushing that mounts to the centerlink is the "stiff' one
-
Also, the threads past the nut on the end of the mounting bracket that contains the upper bushing has raised marks that appear to prevent the nut from being removed. Can the bushing be replaced without removing these raised spots on the threads?
Thank you,
Barry
Besides they other good info given the nut and thread issue is one that you have to improvise and re stack the nut after reattaching. Bob
-
The 67-70 Power Steering idler will have C7ZA 3355 B cast in the arm, As well as FoMoCo or FORD on the other side. The Frame Mounting bracket will not have a hole between the mounting holes-- See a Hole, a Non Ford piece.
Bushings, NAPA has the Bushings for a original C7ZA Idler.
The Bushings are Tough to get out, but can be pressed in by a local machine shop. Hint here! Don't get the orientation screwed up when pressing in the bushings--Won't tell you about that.
Dan @ Chockostang
-
The idler arm with the extra slotted hole in shaft is original ford manual steering with pink code where power steering is yellow.