1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year > 1969 Mustang
1969 Firewall hole size needed.
Scott302:
I am looking for the diameter of this hole in the center of the firewall. The under dash main harness with a grommet and wires for the wiper, engine gauge feed harness and others pass through here.
Regards,
Scott
jwc66k:
I would assume that is for underdash harness, 14401, and if I got to punch a feed thru hole for any harness, I measure the diameter of the grommet's groove and use a chassis punch.
Him
Scott302:
Not why I need it. I need to verify the original dimension.
Scott
JohnSlack:
Scott,
If nobody else answer before I get out to the shop this afternoon and slide the harness out. I'll let you know.
John
JohnSlack:
--- Quote from: JohnSlack on March 27, 2024, 06:32:45 PM ---Scott,
If nobody else answer before I get out to the shop this afternoon and slide the harness out. I'll let you know.
John
--- End quote ---
Sorry Scott I couldn't get the harness out to measure the hole for you.
John
Navigation
[0] Message Index
[#] Next page
Go to full version