ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1968 Mustang => Topic started by: mhubert89 on June 24, 2015, 02:01:11 PM

Title: What color were these parts supposed to be ?? April 68 Dearborn
Post by: mhubert89 on June 24, 2015, 02:01:11 PM
Hi ,

Can someone told me wich color suppose to be this parts in my 68 fastback built in dearborn on april 16th ?
The 2 valance light case, are the bigger one going under the one was paint body color ..

the trap door latch suppose to be wich color ( not in picture ), zinc phol like the loop ?
Title: Re: Wich color this parts suppose to be ??
Post by: Bob Gaines on June 24, 2015, 04:58:01 PM
Quote from: mhubert89 on June 24, 2015, 02:01:11 PM
Hi ,

Can someone told me wich color suppose to be this parts in my 68 fastback built in dearborn on april 16th ?
The 2 valance light case, are the bigger one going under the one was paint body color ..

the trap door latch suppose to be wich color ( not in picture ), zinc phol like the loop ?
As it pertains to Dearborn- TYPICALLY  the tie downs were bare steel, the trans crossmember bare steel ,the two 1968 parklight backing plates zinc dichromate(gold) ,the single 1967(not used on 68)  parklight backing plate was gold,  the fuel line crossover was black  .
Title: Re: Wich color this parts suppose to be ??
Post by: mhubert89 on June 24, 2015, 07:35:18 PM
Quote from: Bob Gaines on June 24, 2015, 04:58:01 PM
As it pertains to Dearborn- TYPICALLY  the tie downs were bare steel, the trans crossmember bare steel ,the two 1968 parklight backing plates zinc dichromate(gold) ,the single 1967(not used on 68)  parklight backing plate was gold,  the fuel line crossover was black  .

perfect , Thanks

Mathieu
Title: Re: What color were these parts supposed to be ??
Post by: mhubert89 on July 15, 2015, 05:28:28 PM
wich color suppose to be the interior trim panel bracket ( all little bracket everywhere to bolt the interior panel ) red or black ?

front & back bumper bracket ? black ?
ignition switch bracket ? zinc dich ?
Title: Re: What color were these parts supposed to be ??
Post by: J_Speegle on July 15, 2015, 08:19:09 PM
Quote from: mhubert89 on July 15, 2015, 05:28:28 PM
wich color suppose to be the interior trim panel bracket ( all little bracket everywhere to bolt the interior panel ) red or black ?

Somewhat glossy black - possibly dipped

Quote from: mhubert89 on July 15, 2015, 05:28:28 PM
front & back bumper bracket ? black ?

Semi-gloss black - except for the insert nut at the rear
Title: Re: What color were these parts supposed to be ??
Post by: mhubert89 on July 15, 2015, 08:49:54 PM
Quote from: J_Speegle on July 15, 2015, 08:19:09 PM
Somewhat glossy black - possibly dipped

Semi-gloss black - except for the insert nut at the rear

thanks again J !