ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1970 Mustang => Topic started by: blackjadeboss on July 20, 2015, 08:03:41 PM

Title: 70 - Firewall clamp for wire harness at Blower Motor
Post by: blackjadeboss on July 20, 2015, 08:03:41 PM

I am looking for a source for the rubber coated J clamp that held the wire harness for the alternator, voltage regulator and starter solenoid.

It attached to the outer top blower motor stud.

Has anyone sourced that new ?

Thanks in advance.

Keith

Title: Re: Firewall clamp for wire harness
Post by: J_Speegle on July 21, 2015, 12:01:40 AM

What year?

Title: Re: Firewall clamp for wire harness
Post by: blackjadeboss on July 21, 2015, 07:41:26 AM

It's a 70, and in fact I should have posted this in the Boss, or Dearborn section.

My bad.

Title: Re: Firewall clamp for wire harness
Post by: rockhouse66 on July 21, 2015, 08:47:25 AM

This is the clamp you are looking for?  I see this routing on most Dearborn cars but some are clipped under the brace like is common on a Metuchen car.

Title: Re: Firewall clamp for wire harness
Post by: blackjadeboss on July 21, 2015, 11:11:19 AM

Indeed it is!

Title: Re: 70 - Firewall clamp for wire harness at Blower Motor
Post by: J_Speegle on July 21, 2015, 02:28:26 PM

Just picked them up at wrecking yards or made them from scratch. Believe they are the same as the ones used for the AC vacuum lines normally directly above on AC cars (another source)

Fix the title to represent what you were asking about ;)

Title: Re: 70 - Firewall clamp for wire harness at Blower Motor
Post by: blackjadeboss on July 21, 2015, 02:46:44 PM

Thanks Jeff.

Title: Re: 70 - Firewall clamp for wire harness at Blower Motor
Post by: specialed on July 22, 2015, 10:29:03 AM

the a/c line strap holder is smaller  but you can find that size strap holder under dash wiring harness.

Title: Re: 70 - Firewall clamp for wire harness at Blower Motor
Post by: J_Speegle on July 22, 2015, 02:43:59 PM

Quote from: specialed on July 22, 2015, 10:29:03 AM

the a/c line strap holder is smaller  but you can find that size strap holder under dash wiring harness.

The heater motor one is that wide??  Thanks for the correction for the OP

Title: Re: 70 - Firewall clamp for wire harness at Blower Motor
Post by: blackjadeboss on July 22, 2015, 02:59:48 PM

I have both ... so I can measure. My original f/w piece is pretty ugly.