ConcoursMustang Forums
1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1970 Mustang => Topic started by: Rainier42 on February 20, 2016, 12:38:41 PM
-
Anyone know if the door jamb vent grille for the SR models are reproduced? Can't seem to find them.
-
I don't think they are, I've only ever seen this restomod repro:
http://www.ebay.com/itm/70-71-Ford-Mustang-Polished-Door-Jam-Vent-/310326063364?vxp=mtr&hash=item4840dff104
Don't give up on your originals if they're bleachy looking, just refinish them:
http://www.eastwood.com/ew-plastic-resurfacer-matte-black-aerosol.html
-
Plastic on mine is good ... it's the rubber flaps that are deteriorating. Is there any way to replace just those?
-
Don't give up on your originals if they're bleachy looking, just refinish them:
http://www.eastwood.com/ew-plastic-resurfacer-matte-black-aerosol.html
The originals (plastic outer section) were not matte in finish on the cars I've seen. The cars I've seen and owned they were shinny and very smooth. Have used Back to Black on those with decent IMHO outcome if they have started to break down just get some replacements
Plastic on mine is good ... it's the rubber flaps that are deteriorating. Is there any way to replace just those?
Never tried but since you can't see the back side you might look at taking off the old flaps are replacing them with new material I sure would try. But, for me, that is the fun part of restoring - figuring out new processes or ways to accomplish the finished look we're seeking
Ifs funny how often you can find something in your everyday life that will work for a project like this. I know I've used milk cartons and margarine containers to make parts for some of my projects - as an example
-
The originals (plastic outer section) were not matte in finish on the cars I've seen. The cars I've seen and owned they were shinny and very smooth. Have used Back to Black on those with decent IMHO outcome if they have started to break down just get some replacements
Never tried but since you can't see the back side you might look at taking off the old flaps are replacing them with new material I sure would try. But, for me, that is the fun part of restoring - figuring out new processes or ways to accomplish the finished look we're seeking
Ifs funny how often you can find something in your everyday life that will work for a project like this. I know I've used milk cartons and margarine containers to make parts for some of my projects - as an example
Replacements ... that's the issue, not sure anyone is making these.
Will have to pull one off again and take a real good look at the back ... the vent is pieced together with a thin rubber sandwiched in between. I believe I can come up with a rubber replacement but will need to figure out how to separate the plastic pieces without breaking anything.
-
Replacements ... that's the issue, not sure anyone is making these.
I was thinking donor car rather than the catalog and credit card solution.
Since these are normally very protected from the elements and the sun the ones I see (unless scratched up by a PO) are almost always perfect
Just my first go to solution - but that is me :)
-
For a project like this I would agree, find some nice originals from a donor car or a swap meet or junkyard. I dont think they can easily be taken apart and replaced.
-
........ I dont think they can easily be taken apart and replaced.
Yea but I can think of at least a couple of guys that would try ;)
-
I think you can "fix" them. They do pop apart, and I think a sheet of some sort of black plastic in between and then cut with an exacto knife around three sides of each vent. I'm going to try, just haven't come up with anything plastic yet to try it with....