ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1968 Mustang => Topic started by: preaction on May 29, 2016, 12:05:28 PM

Title: Automatic trans C6 vacuum line ID
Post by: preaction on May 29, 2016, 12:05:28 PM

Does the end of this vacuum line look familiar to anyone ? The 180* bend would be at the back of the intake manifold.

Title: Re: Automatic trans C6 vacuum line ID
Post by: J_Speegle on May 30, 2016, 05:36:43 PM

Only recall finding a curl like that at the rear (vacuum modulator) end of the line. Here is an example of a 68 C6 rear section. The line does seem to be deformed (bent upward) but you can make out the curl



(http://www.concoursmustang.com/forum/gallery/5/6-300516163615-58321792.jpeg)




And a poor shot of the same application at the intake end - just a straight tube as expected and on other applications


(http://www.concoursmustang.com/forum/gallery/5/6-300516163614-5831233.jpeg)

Title: Re: Automatic trans C6 vacuum line ID
Post by: preaction on May 30, 2016, 06:51:54 PM

Thanks Jeff, this was a part from WCCC I had a feeling the bend on the intake end was too much, sorry Scott But thanks for looking ! ;)