ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1967 Mustang => Topic started by: 67gta289 on July 31, 2016, 02:29:44 PM

Title: 67 fastback vent fastener
Post by: 67gta289 on July 31, 2016, 02:29:44 PM

Of my 10 washers #359972, one was filled with a sealant, nine were not.  Also one had fallen out. Refer to pics.  Should these be sealed?

Title: Re: 67 fastback vent fastener
Post by: jwc66k on July 31, 2016, 04:30:23 PM

John,
Did you look at the body assembly drawing (AM0016, pg52)? It shows no sealant as that spherical washer is used to center the force of the nut on a surface that is at an angle. As much as I would want a sealant in this application, Ford did not. (It's the same spherical washer used on back-up lights for the same reason, an angled surface.)
OT (sort of). It's been a while since I reviewed a 67 Fastback rear vent assembly. I note there is a drain hose again on the rear vents after being introduced in 65 Fastbacks, and deleted in 66 Fastbacks. Just an observation.
Jim