ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1969 Mustang => Topic started by: Wills70 on February 04, 2017, 07:01:39 PM

Title: 1969 351w shaker bracket pictures ?
Post by: Wills70 on February 04, 2017, 07:01:39 PM

Hi, I am looking for some pictures of an original hold down bracket , specifically the engraving to add the 2v  and  4v engraving to my reproduction bracket .  Any help would be greatly appreciated !
Thanks Will      wmibs@ymail.com   

Title: Re: 1969 351w shaker bracket pictures ?
Post by: Brian Conway on February 10, 2017, 03:20:58 PM

Sure about that ?  Never seen a support bracket stamped with anything.  Have seen a mid-plate stamped with 2V and 4V.  Brian

Title: Re: 1969 351w shaker bracket pictures ?
Post by: 7Lscjracer on February 10, 2017, 11:05:48 PM

I have an original one stashed away, and they are stamped 2V and 4V for the two intake manifold bolt holes.
I'll dig it out and take pictures when I'm back from vacation in March.

Title: Re: 1969 351w shaker bracket pictures ?
Post by: Aussiemach on February 11, 2017, 06:27:16 PM

(http://www.concoursmustang.com/forum/gallery/6/331-110217172504-67482438.jpeg)
(http://www.concoursmustang.com/forum/gallery/6/331-110217172503-6747816.jpeg)

Title: Re: 1969 351w shaker bracket pictures ?
Post by: Wills70 on February 12, 2017, 10:34:58 AM

Thanks for all the replies !  Aussiemach is your bracket a Ford original ?
7Lscjracer - I very much like to see yours as well if you can find the time to post a picture
Again_ Thanks for the help!
Will

Title: Re: 1969 351w shaker bracket pictures ?
Post by: Aussiemach on February 13, 2017, 04:04:06 AM

that is a picture I had from don't know where. Below is a picture of mine which I purchased second hand years ago, I'm fairly sure it's original Ford

(http://www.concoursmustang.com/forum/gallery/6/331-130217025649.jpeg)

Title: Re: 1969 351w shaker bracket pictures ?
Post by: Wills70 on February 14, 2017, 08:35:01 PM

Thanks Aussiemach ! Exactly  what I was  looking for.  I am a machinist by trade and going to CNC engrave this on my bracket.