ConcoursMustang Forums

Restoring - General discussions that span across many different groups of years and models => Processes, Products & Techniques => Topic started by: 9F94M567042 on February 25, 2018, 02:46:34 PM

Title: Ford Distributor Rebuild
Post by: 9F94M567042 on February 25, 2018, 02:46:34 PM
Good Morning,
I have read all the posts about Tim O'Conner and his Ford Distributor Rebuild Services.
Checking his website, he says he might start again in October of 2017. I have sent him
an email, but have not heard back. Does anyone have any recommendations for
another supplier of this type of service(s) if he does not wish to continue?
I recently picked up a distributor in what could have been used in my April '69 Cougar.
Distributor has date code of 8M16 which would have been December '68.
Thanks Much
Title: Re: Ford Distributor Rebuild
Post by: carlite65 on February 25, 2018, 02:53:28 PM
try dan nolan at mustangbarn.com. located in south east penn.
Title: Re: Ford Distributor Rebuild
Post by: 69428SCJ on February 25, 2018, 03:50:13 PM
I do believe Bill Upham at Mansfield Mustang offers a rebuild service.
Title: Re: Ford Distributor Rebuild
Post by: krelboyne on February 26, 2018, 01:18:02 PM
I have used http://ignitionengineering.com/ (http://ignitionengineering.com/), John Cause owner. He is in Anaheim, California.
Did my 1969 CJ distributor back in the 1990's.
Title: Re: Ford Distributor Rebuild
Post by: 67gtasanjose on September 15, 2018, 08:11:17 AM
Has anyone heard any news on Tim O'Conner?
Title: Re: Ford Distributor Rebuild
Post by: RoyceP on September 15, 2018, 12:08:31 PM
Last I checked about 6 months ago he was enjoying his race car and not restoring anything for anyone else.


Has anyone heard any news on Tim O'Conner?