ConcoursMustang Forums
Restoring - General discussions that span across many different groups of years and models => Drivetrain => Topic started by: Oz390 on September 18, 2010, 09:13:58 AM
-
Anyone have a photo of where the partial VIN stamp would be on a '68 289?
San Jose car, if it matters.
Know "back of the block" but with the engine in, and dirt, grime, a specific area to look at would be helpful. Need to see if one exists on a Cal Special I just bought for Queensland registration.... need both body VIN and an engine number to register here.
Don't want to stamp a new number if the original is there somewhere... would think it "should" be as its a later 68 model (late april 68 build date). Looked with the shops mechanic for a while today, neither of us found it, but were not sure exactly where it "should" be... and prefer not to pull the engine to get a better view.
-
Flat spot on top of the block, right behind the back of where the intake would be. Stampings are faint to deep.
-
I sure do have exactly that picture.
This is a 68 coupe, w/289/PS/AC/C4/2V
Built Jan 23rd at the San Jose Plant.
http://www.rogerarrick.com/mustang/enginevin_800.jpg
Roger