ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1967 Mustang => Topic started by: cmfuser01 on March 23, 2018, 07:35:26 PM

Title: 1967 GT 350 (Early 10/66) Carpet Detail - Kick Panels to Sill Plate Area
Post by: cmfuser01 on March 23, 2018, 07:35:26 PM

I'm looking for photos of how the carpet transitions from the kick panel to sill plate area. My car had pretty much a straight vertical cut up from the floor to the sill plate but I think the carpet had been replaced so not sure that detail is correct. Also, the ACC non mass-backed carpet set I have seems to have sort of a molded diagonal feature in that same area so looking for photos and guidance.

Thanks!

Title: Re: 1967 GT 350 (Early 10/66) Carpet Detail - Kick Panels to Sill Plate Area
Post by: Fastback2013 on March 25, 2018, 05:23:36 AM

Hello,

I can provide you a picture that I took at the passenger side.
I hope this is what you looking for.
If anything else is needed, just ask ;)
Kind regards,
Jeroen

Title: Re: 1967 GT 350 (Early 10/66) Carpet Detail - Kick Panels to Sill Plate Area
Post by: cmfuser01 on March 25, 2018, 06:20:46 AM

Quote from: Fastback2013 on March 25, 2018, 05:23:36 AM

Hello,

I can provide you a picture that I took at the passenger side.
I hope this is what you looking for.
If anything else is needed, just ask ;)
Kind regards,
Jeroen

Yes - thank you.