ConcoursMustang Forums
Restoring - General discussions that span across many different groups of years and models => Interior & Trunk => Topic started by: Horsman on October 25, 2019, 10:24:36 AM
-
Pulled my original carpet to release some factory clips holding fuel lines and the speedo cable to the floor. Carpet is in great condition but has some minor stains. Has anyone cleaned and reused their original carpets? Curious about a good process the will not damage or remove the color from the fabric. Thanks in advance.
-
Yes... I first vacuumed over and over with a nylon tire brush between times and I then shampooed several times brushing several times to dislodge any small particles of gravel and then I dyed with SEM dye brushing before it had a chance to harden. It turned out pretty well. I don't have any pics of the after but the before was pretty dirty and faded. It looks much better than the new carpets available today. :)
TOB
-
May sound crazy & I have not done this with 50 year old carpet... I have done this on 2 vehicles in the last 6-7 years, most recent was last week.
Pull the carpet, load it up in the truck, head to the local car wash, soak (really soak it) the carpet with "tire cleaner" (Simple green if the car wash does not have it on the dial), let it set for several min, scrub any stained areas with a brush, turn to soap & hose down really really well, flip to rinse & spay until water runs clear. After all this take it home & let it dry, may take a few days.
The 98 GT convertible carpet would have looked like new if it had not been sun faded. Even removed all of the coffee stains from the saddle carpet!