ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1969 Mustang => Topic started by: cob428 on December 22, 2010, 05:45:17 AM

Title: buck tag
Post by: cob428 on December 22, 2010, 05:45:17 AM

I've got a '69 Mach 1 that was built at the Metuchen plant 11/68 found the original buck tag buried in the deep crevices of the trunk. Where is it suppose to be mounted, what type of of hardware (bolt, screw)? Is it painted or natural (mine is nothing but crusty rusty)?

Title: Re: buck tag
Post by: J_Speegle on December 22, 2010, 09:12:34 PM

In 69 at NJ they were typically attached before the engine compartment was painted with a single Phillips head screw (flat one with the intergrated washer design) to the passenger side inner fender panel at approx the mid to forward edge of the hood hinge so that it can be read from the passenger side of the car

Hope this helps

Title: Re: buck tag
Post by: SCJSTU on December 28, 2010, 10:06:30 AM

here ya go

Title: Re: buck tag
Post by: cob428 on December 29, 2010, 06:40:18 AM

Wow, can't get any better than that!!! Thanks

Title: Re: buck tag
Post by: fla2005 on December 29, 2010, 09:48:19 AM

If your car has the original inner fender panel should be a small hole at the location for tag and screw.