ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1967 Shelby => Topic started by: Boss/Cyclone on February 11, 2021, 05:50:17 PM

Title: GT500 crank pulley finish
Post by: Boss/Cyclone on February 11, 2021, 05:50:17 PM: I have been doing a little cleanup on my car. While replacing the clutch fan I pulled the crank pulley and was wondering what is the proper finish? Attached is a photo of how it looks now.
Title: Re: GT500 crank pulley finish
Post by: J_Speegle on February 11, 2021, 06:19:21 PM: Sprayed semi-gloss black
Title: Re: GT500 crank pulley finish
Post by: Boss/Cyclone on February 11, 2021, 06:22:05 PM: Thanks Jeff, I assumed that was it but just wanted to confirm before taking action.
Title: Re: GT500 crank pulley finish
Post by: J_Speegle on February 11, 2021, 06:42:53 PM: No problem plus the thread will serve others having the same question in the future
Title: Re: GT500 crank pulley finish
Post by: Bob Gaines on February 11, 2021, 08:24:08 PM: To make it look like assemblyline it should be semi gloss black with a machined finish outer edge.
Title: Re: GT500 crank pulley finish
Post by: Boss/Cyclone on February 11, 2021, 09:22:05 PM: Quote from: Bob Gaines on February 11, 2021, 08:24:08 PM
To make it look like assemblyline it should be semi gloss black with a machined finish outer edge.
Just the outer edge and bottom middle, like in your photo? The rest is semi gloss black?
Title: Re: GT500 crank pulley finish
Post by: Bob Gaines on February 11, 2021, 10:52:20 PM: Quote from: Boss/Cyclone on February 11, 2021, 09:22:05 PM
Just the outer edge and bottom middle, like in your photo? The rest is semi gloss black?
Yes ,like in the photo. The rest is semi gloss Black.
Title: Re: GT500 crank pulley finish
Post by: Bob Gaines on February 11, 2021, 10:56:10 PM: The machined inner center is typically covered by the crank bolt washer . So do what you think is best for you in that regard IMO.