ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1967 Mustang => Topic started by: V8_bloke_28 on June 21, 2021, 06:00:22 AM

Title: Vinyl dipped clip
Post by: V8_bloke_28 on June 21, 2021, 06:00:22 AM

Hi
Im after this clip/clamp that holds the little vacuum hoses on the firewall.
Car is 67 fack 390gt auto. San Jose.
It has factory ac.
Can someone tell me what it?s actually called and where I can get one from?
Cheers

Title: Re: Vinyl dipped clip
Post by: ruppstang on June 21, 2021, 08:37:55 AM

IMHO they are not reproduced. You will have to find a original or make one. They are not that hard to make.

Title: Re: Vinyl dipped clip
Post by: Bob Gaines on June 21, 2021, 10:27:03 AM

Quote from: ruppstang on June 21, 2021, 08:37:55 AM

IMHO they are not reproduced. You will have to find a original or make one. They are not that hard to make.

+1. I have had to do both on more then one occasion over the years.

Title: Re: Vinyl dipped clip
Post by: preaction on June 21, 2021, 11:53:35 AM

You could try WCCC.

Title: Re: Vinyl dipped clip
Post by: 1967FEGT on June 21, 2021, 03:07:16 PM

I have one in about NOS condition if you're in need.

Title: Re: Vinyl dipped clip
Post by: J_Speegle on June 21, 2021, 05:46:43 PM

Quote from: ruppstang on June 21, 2021, 08:37:55 AM

IMHO they are not reproduced. You will have to find a original or make one. They are not that hard to make.

+2 Were used on other Ford and Mercury products but you'll need to double check if they are the same size. We did get into a short discussion about a possible difference  but we didn't go down that rabbit hole so the question went unsolved at that point in the conversation