ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1969 Mustang => Topic started by: 69 black r code on January 09, 2022, 02:15:12 AM

Title: Engine mount brackets and insulator finish
Post by: 69 black r code on January 09, 2022, 02:15:12 AM

4-69 NJ 428cj
After doing a search I have found that the engine mount block bracket and frame bracket should be natural steel. Should the rubber insulator bracket be natural as well?

Title: Re: Engine mount brackets and insulator finish
Post by: Bob Gaines on January 09, 2022, 11:50:38 AM

Quote from: 69 black r code on January 09, 2022, 02:15:12 AM

4-69 NJ 428cj
After doing a search I have found that the engine mount block bracket and frame bracket should be natural steel. Should the rubber insulator bracket be natural as well?

It could be but more typically the upper portion was blacked out with the rubber coating or paint and the lower "ears" portion that the single motor mount bolt goes through was bare steel.

Title: Re: Engine mount brackets and insulator finish
Post by: 69 black r code on January 09, 2022, 01:37:36 PM

Thank You Bob. that's what I needed.