ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1967 Mustang => Topic started by: ntures 2019 on April 25, 2022, 11:13:54 PM

Title: 9 inch rear end snubber
Post by: ntures 2019 on April 25, 2022, 11:13:54 PM

one on the left was taken off a 67-mustang k code for comparison to the bigger one which was taken off a 67 390  anyone know why the one on the right is bigger or what it was made for ?

Title: Re: 9 inch rear end snubber
Post by: ntures 2019 on April 26, 2022, 12:17:24 PM

must not have loaded, i just updated it

Title: Re: 9 inch rear end snubber
Post by: Bob Gaines on April 26, 2022, 12:45:58 PM

Quote from: ntures 2019 on April 25, 2022, 11:13:54 PM

one on the left was taken off a 67-mustang k code for comparison to the bigger one which was taken off a 67 390  anyone know why the one on the right is bigger or what it was made for ?

It is not a pinion shield for a Mustang application. The rubber snubber is the only easily usable part. You could cut the big one down I suppose but to do it right it is probably more trouble then it is worth.   

Title: Re: 9 inch rear end snubber
Post by: 67350#1242 on April 27, 2022, 09:40:27 AM

I once cut one of these down and drilled a new hole for the bumper.   Made a real good facsimile of an original.

Title: Re: 9 inch rear end snubber
Post by: ntures 2019 on May 07, 2022, 01:04:57 AM

any idea what its for then ?

Title: Re: 9 inch rear end snubber
Post by: Scode67FB on May 07, 2022, 01:31:31 AM

Probably Torino. I think the Galaxie version is longer.